Manual press brake is divided into mechanical press brake manual and electric manual press machine. This plate bending machine manual can be used to make distribution box, electronic switch box, fuse brake and distribution cabinet, it is also widely used in conveying machinery, handling boxes, as well as the process of all kinds of box, plate. Manual bending brake is universally popular with many customers at home and abroad with the characteristics of light, energy saving, high efficiency, high production, wide application, easy to handle.

Operating Rules of Manual Metal Sheet Bending Machine:

1. Clean the hand press brake and surrounding area before an operation, remove debris, check whether the machine can operate normally and whether the tool is installed in place. In addition, operators should wear protective equipment before operating the cnc hydraulic press brake manual press brake.
2. Requirements for work
(1) the operator must undergo the necessary technical training and understand the structural performance, technical parameters and operational requirements of the machine, and comply with the general operating safety requirements of the machine tool.
(2) when the plate is bent, the operator must pay attention to prevent the cutting of the plate.
(3) when the workpiece is processed, if it is not properly positioned, then the parking should be stopped immediately, and the correction cannot be corrected by hand during operation, which can be dangerous.
(4) it is forbidden to bend over the bending performance of the machine to avoid damaging the machine.
3. The operating
Install the die pressing knife and the positioning of the processing, then adjust the position of the limit stroke. Put the workpiece in, and bend the bending process. After bending, take out the bent piece and move on to the bending of the next piece.
4. Stop the machine
Remove the workpiece, exit the process of processing, cut off the power. Put tools, gauges and materials in place and then clean up the site.
5. The maintenance
(1) check the positioning device, die presser and fastener, check whether it is normal and tighten.
(2) the machine shall be lubricated according to the regulations, and the dust and oil pollution on the manual sheet bending machine shall be removed in time so that the machine can operate normally.