Product Description

How to use

STEP 1. Check the affected part.

STEP 2. Select the product that matches the affected part.

STEP 3. Place the product on the affected part and fix it with the Velcro bands.

How to adjust

When the product does not fit the lesion due to size or swelling

A. Method of molding using water

    1. Remove the air mesh & Velcro bands.
    2. Immerse the part of the entire product that requires molding in water at 60℃~70℃(140℉~158℉).
    3. After about 20~40 seconds, remove it, gently shake it, attach the air mesh, mold it, appropriately on the effected part, and fix it

        with elastic bandage or Velcro band.
    4. Wait for a minute or so, then confirm that the product is completely hardened.

B. Method of molding using the heat

    1. Place the product in the heater and close the cover.
    2. Turn on the power switch and set the desired heating intensity and time.
    3. When the heating is over, take out the product and mold to the affected part.
    4. Wait for a minute or so, then confirm that the product is completely hardened.

Precautions

1. It must be used under the guidance of a specialist.
2. Caution should be exercised because severe deformation of the product may cause changes in the function of this product.
3. Do not excessive heat or force on the product.
4. Be careful when there is swelling in the affected area and do not reuse a product for multiple patients.

Feature

A. It is Ready-made type and it is molded according to the wear part, so it is easy to treat and quick treatment is possible.
B. Remolding is possible, and appropriate treatments are possible depending on the degree of deformation and the condition of the

    affected part of the same patient.
C. It is lightweight and excellent in strength.
D. Using air mesh and Velcro strap band it has excellent ventilation and easy to attach and detach.
E. X-ray transmission is possible, so you can shoot while wearing the product.