Outline, Function and Advantages

Battery is a device which puts out chemical energy into electrical energy.

Lead dioxide panel(Pbo2) and general lead panel(Pb2) are placed, facing each other in thin Sulfuric acid electrolyte in battery. Lead battery generates electricity by chemical changes. According as electricity discharges in battery, + and –pole plates changes to lead sulfate, electromotive force grows lower, + pole, the density of sulfuric acid decreases, and discharging stops. If the battery is charged by letting current flow toward + pole, electromotive force will be recovered, + pole will turn into general lead, and the density of thin sulfuric acid will grow thicker.

But, the sulfate sticking to the pole plate during the discharging cycle will not be separated but accumulated on the pole plates. If this accumulation increases, the capacity of electricity storage will decrease, and the amount of electricity will also decrease, even though the battery is fully charged. If our product, power saver is connected to +,- terminal of the battery, sulfate sticking to the pole plates by pulse signal will be resolved into molecular level, and the much cleaner pole plates enable the capacity of battery to be improved.

Therefore, our product is a device which provides electricity stably and extends the useful life of battery.

The following effects will be shown 10 hours after this product is installed.

* If the performance of battery is lower than 40%, it can not be restored as a new one.

Installation and Checking Points

Put in the product into the electrical socket in your car.

If you turn on the ignition to ACC mode, electric power will be applied, and the battery voltage will be displayed on Power supply panel. If the battery voltage is lower than 11.7V, it will be in bad state, signaling the changes for batteries. If the battery voltage is more than 12V, it will be in good state.

If you start the engine, more than 13.2 Voltage will be displayed. If the voltage decreases lower than 12 V while driving, do not hesitate to visit car repair shop, and check if the voltage of electricity generated by generator.

Install this product, turn the ignition to ACC mode, and record the voltage displayed on Powersaver. If the voltage increases more than the recorded voltage before driving when turning the ignition to ACC mode after you install the product and drive the car more than 10 hours of accumulated driving, the battery capacity will be improved just like a new one. It is the evidence of fuel efficiency improvement and exhausted fume reduction by supplying rated voltage.

LED Lamp

Mobile device can be charged at high speed because USB terminal for smart phone charge is attached.